霍尼威尔仪器的设置任务注解
Set-up Tasks
Major set-up tasks
As shown in Figure 1-2, there are four major tasks that you must complete to "Set Up" the DR4500A
recorder for operation. For easy reference the section numbers for each task are shown. 
 
START
Ready for 
Operation

1.Determine your recorder's See Section 2 hardware components and software functions 2.Mount the recorder flush in See Section 2 a panel, or on the surface of a panel or a wall 3.Connect the power and See Section 2 input/output wiring.
4.Follow the simple keystroke       See Sections 3 & 4
  sequences and English
  language prompts to
  "configure" the functional
  characteristics of your
  recorder.

For Model DR45AR,  also see Appendix A
21402
 
 
Figure 1-2   Set-up Tasks

Honeywll仪器安装说明

2. Installation 2.1 Overview Introduction Installation of the DR4500A Recorder consists of mounting and wiring the recorder according to the instructions given in this section. Read the preinstallation information, check the model nu mber interpretation and become familiar with your model selections, then proceed with installation. What’s in this section? This section contains the following information: Topic See Page 2.1 Overview 7 2.2 Model Number Interpretation 13
2.3 Mounting Considerations  and Overall Dimensions  16
2.4 Mounting Methods  17
2.5 Wiring Prerequisites  27
2.6  Input Wiring Procedures  29
2.7 Output Wiring Procedures  39
2.8  Option Wiring Procedures  45
2.9  Lockout Switch Configuration  54

更多 记录纸、记录笔可咨询工业记录纸、工业记录笔 网站